Step-By-Step Instructions To Repair A Leak
Make sure the area is clean and dry. If the fitting is wet, use toilet paper to wick up all the water and a blow dryer to make sure the area is dry. Use a wire brush or sandpaper to clean the area.
Apply the resin directly from the bottle; there’s no mixing or adding of hardeners or catalysts. Apply a continuous feed or resin all around the pipe, filling the area between the fitting and the pipe.
Let the resin air cure for 24 hours. If required, after your first application is cured, you can add any resin to fill voids or to strengthen and repair. The added resin will chemically weld to the original pieces and the already applied lotion.
Step-By-Step Instructions To Repair A Screw/Nail Hole
Remove the screw; the area must be clean and dry. Use a wire brush or sandpaper to clean the area.
Apply resin directly from the bottle. Put the resin into the hold and then; fill it up to the size of about a dime. Let the resin air cure for 24 hours.